Accessories maintenance is easy to be overlooked
Many car owners are very careful in the selection of accessories, but easy to overlook accessories maintenance after installation, so that in the case of the gradual increase in car driving journey, accessories are very susceptible to wear and life expectancy is reduced. Now we will provide the following six Subaru 2.5i Outback Sport Style 2013 Body Side Moulding maintenance considerations for the owners' reference.
Secret 1: avoid heat
If the engine piston temperature is too high, it is easily lead to overheating and burn and blow up; the rubber seals, triangle tape, tires are easy to premature aging, performance degradation and shorten life if overheat; if engine, generator, regulator electrical equipment coil is overheating, they will be easily burned and scrapped.
Secret 2: Avoid dirty
If the fuel filter, oil filter, air filter, hydraulic oil filter, and all kinds of filters and other parts are too dirty, it will lead to the deterioration of the filtering effect. Water tank heat sink, air-cooled engine block and cylinder head heat sink, cooler heat sink parts being too dirty will cause poor heat dissipation, and the temperature is too high.
Secret 3: Avoid being reverse
Engine cylinder head gasket cannot be installed reversely during installation, otherwise it will lead to premature ablation damage of the cylinder head gasket; engine fan blades cannot be installed backwards; for the tire with herringbone pattern and direction pattern, the ground glenoid should make the herringbone tip pointing to the rear after being installed.
Secret 4: Avoid missing
Piece of engine air locks should be installed in pairs, if missing install or deletion will cause the valve out of control and crash piston and other Subaru Forester parts; engine connecting rod bolts, flywheel bolts installed on the drive shaft bolts, cotter pins, locking screws, fuse or spring pad locking device, which may cause serious failure in use once missing loaded.
Secret 5: Avoid oil
Engine dry air cleaner paper element, if stained with oil, is easy to make higher concentration of the mixed gas inhaled within the cylinder, and make the amount of air insufficient, increase fuel consumption, reduce engine power; If triangle tape coated is dipped with oil, it will accelerate the corrosion of aging; brake friction plate dry clutch, brake band will threaten traffic safety if being stained with oil.
Secret 6: Avoid repeat
Some parts should be used for only one-time, but the individual driver or mechanic reuse in order to save money or do not understand the "taboo", which can easily lead to accidents.
www.auto-bodyparts.net is concentrated on SUBARU exterior auto body parts' developing, producing, selling for almost 8 years, our items including bonnet, spoiler, side visor, front bumper guard, grille, roof luggage rack, door sill plate ,strut bar, carpet and some accessories about SUBARU car.
This article come from: http://www.auto-bodyparts.net/News/142.htm